ETSC 265
Three-Dimensional Modeling (Using SolidWorks)
Fall Quarter 2017
 
 
Instructional Videos 
-
Video 28, SolidWorks, How to Create an Assembly - Creating a Hammer - Mating the Handle and Head. In this video you will learn the basics regarding SolidWorks Assemblies by putting together two SolidWorks parts, a hammer handle and a hammer head. 

-
Video 29, SolidWorks, How to Create an Assembly that Moves Sarrus Mechanism - More Assembly Techniques In this video you will learn more about assemblies and mates and various techniques to putting it all together.  We will also discuss part degrees of freedom (6 of them), inserting a multi configuration part, "Select Other" option, Mates Folders, dragging common edges of parts into the assembly for quick mates and more. 

-
Video 30, SolidWorks, How to Create Part Configurations Short Tour - Sarrus Hinge Plate, Part Within a Part. Its like a Part Within a Part.  In this video you will see how to create different SolidWorks part configurations using your Sarrus Mechanism Hinge Plate part model. 

-
Grade Sheet Guidance - How to Determine your Grade on the the FDS of the WDE.  This video explains how your grade is determined on the FDS of the WDE and where you can make concentrate your efforts to improve your grade in Week 5 and for he rest of the quarter.

-
-
-
Week 5 - Student Question about a Creating Split Line Feature for the Sweep Profile Plane on the Crucible Bucket


-
Week 5 - Student Question, Mass Properties are Off on the Crucible Bucket, it's Close, but not Right On